Haier HRF-628DF6 - Levelling and Adjusting Doors; Fitting the Handles; Electrical Supply Connection

13
Levelling the Fridge-freezer and
Adjusting the Doors
resistant materials must be used.
This appliance has front adjustable feet, which can be
used to level the appliance.
adjustable feet. Turn the screwdriver clockwise to raise
the feet (Fig.4-8), and counter-clockwise to lower the feet
(Fig.4-9).
Levelling the Doors
The doors may require some alignment before connecting
the fridge-freezer to the electrical supply. This can be
done by adjusting the levelling feet (Fig.4-8 and Fig.4-9).
To raise the left-hand door turn the left-hand foot
clockwise until it is level (Fig.4-10).
To raise the right-hand door, turn the right-hand foot
clockwise until the it is level.
Fitting the Handles
Use the Allen key from the instruction kit bag.
1.
2. Insert the grub screw into the hole located under each
handle standoff bar.
3.
handle to the door.
4. Fix the cover of top bolts to the right position.
Do not over-tighten the grub screw.
Electrical Supply Connection
Connect the appliance to the electrical supply (220-240 V ~
Connections to the mains supply should be in accordance
with local regulations.
!
The appliance must be plugged into an earthed
socket.
!
Always make sure that the plug is accessible after
the appliance has been positioned.
ArtNo.600-0035 - Adjust
sting the feet
Fig.4-8 Fig.4-9
Fig.4-10
Fig.4-11
Screw cover
Grub screw
Standoff bar
Handle