Press MODE button. For each press, operation
Operation
(1) Unit start
mode changes as follows:
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
(2) Select operation mode
AUTO COOL DRY HEAT FAN
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
o
C
Every time the button is pressed, temp. setting decreases 1
o
C
Unit will start running to reach the temp. setting on LCD.
Press FAN button. For each press, fan speed changes
(4) Fan speed selection
as follows:
AUTO LO MED HI
just press ON/OFF button and unit will run in previous status.
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next time,
ON/OFF TEMP
SET
TIMER
CLOCKSWING
SLEEP
LOCK
RESET
FAN
MODE
HEALTH
1
2
3
4
3
5
Cool Operation
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
Remote controller:
(5) Unit stop
Press ON/OFF button, the unit stops.
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
No reelecting is needed.(TIMER ON/OFFǃSLEEPǃSWING needs reelecting)
10
To Next Page
Loading...
Need help?
General
