Operation
Domestic Air Conditioner
45
Function and control
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
BLANK
TIMER ON TIMER OFF TIMER ON-OFF
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). " "or " "will flash.
3.Press / button to set time.
It can be adjusted within 24 hours.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
Timer On/Off On-Off Operation
Healthy airflow Operation
1.Press to starting
Setting for comfortable conditions.
2.The setting of healthy airflow function
Note:
1.After setting the healthy airflow function, the position
louver is fixed.
4.In cooling and dry, using the air conditioner for a long
time under the high air humidity, condensate water may
occur at the grille .
3.To cancel of the healthy airflow function
Notice: Do not direct the horizontal by hand. This may cause
the louver to run incorrectly and not match the display. If the
louver is not running correctly, stop the unit
for a minute
and then restart and adjust remote controller.
2.In heating, it is better to select the
3.In cooling, it is better to select the
mode.
mode.
TIMER OFF-ON
0.5h
0.5h 0.5h
0.5h
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
After adjusting the time,press button and confirm
the time the ON or OFF button will not flash any more.
4.Confirm timer setting
5.Cancel timer setting
Press the timer button until the time display eliminated.
Press button to enter additional options,Press this
button continuously, the louvers location will cycle between
in the following three locations, to choose the swing location
what you needed,and then press button to confirm.
Press button to enter additional options,Press this
button continuously, the louvers location will cycle between
the three locations again,and then press button to
cancel.
Healthy
airflow
upwarder
Healthy
airflow
downwarder
Present
position
To Next Page
Loading...
