Setting of proper room
temperature
Close doors and windows
during operation
If the unit is not to be used
for a long time, turn off the
main po
w
er supply switch.
Use the timer effectively
Use the louvers effectively
Do not block the air inlet
or outlet
Proper
temperature
During cooling operation
prevent the penetration
of
direct sunlight with
curtain or blind
OFF
Once every
two weeks
Maintenance
Maintenance of Air Purifying Filters
Air Filter cleaning
1. Open the inlet grille by pulling it upward.
1. Open the lnlet Grille
Hold the front panel by the tabs on both
sides and lift it until it stops with a click.
Remote Controller Indoor Body
Do not use water, wipe the controller
with a dry cloth. Do not use glass
cleaner or chemical cloth.
Wipe the air conditioner by using a
soft and dry cloth. For serious stains,
use a neutral detergent diluted with
water.Wring the water out of the
cloth before wiping, then wipe off the
detergent completely.
Do not use the following for cleaning
Spirits, benzene, thinner or cleanser
may damage the coating of the unit.
Hot water over 40°C (104°F) may
cause discoloring or deformation.
2.
Slide the knob slightly upward to release the
then withdraw it.
3. Attach Air Purifying Filters
Put air purifying
into the right
and left
frames (one in each).
4.
(Necessary installation)
Detach old Air Purifying Filter
Attention:
The white side of the photocatalyst air purifying
faces outside, and the black
side faces the unit. The green side of the bacteria-inhibiting air purifying
faces outside, and the white side faces the unit.
5. Close the Inlet Grille
Close the grille securely.
Note:
The photocatalyst air purifying will need to be ‘recharged’ from time to time.
This air filter should be exposed to the sunlight every six months to help
the photocatalyst maintain purifying qualities.
The bacteria-inhibiting can be used for a long time without need for
replacement. However, you should remove dust frequently by using a vacuum
cleaner or tapping the
lightly. This will ensure good performance.
When not in use, keep the bacteria-killing medium air purifying filter in cool and
dry conditions and avoid prolonged exposure to direct sunlight as this may reduce
the effectiveness of the filter.
2. Remove the (left and right side).
Push up the
centre tab slightly until it is released
from the stopper, and remove the
downward.
3. Clean the
Use a vacuum cleaner to remove dust, or wash the
with water. After washing, dry the completely
in the shade.
4. Attach the
Attach the
correctly so that the “FRONT”
indication is facing to the front. Make sure that
the
is completely behind the stopper.
If the right and left
are not attached correctly,
that may cause defects.
5. Close the inlet grille.
5
To Next Page
Loading...
