▶ Remove all packaging materials, keep them out of childrens reach and dispose them
in an environmentally friendly manner.
▶ Clean the inside and outside of the appliance with water and a mild detergent before
putting any food in it.
▶ After the appliance has been levelled and cleaned, wait for at least 6 hours before con-
necting it to the power supply. See Section INSTALLATION.
▶ Precool the compartment for 2 hours at high settings before loading with food. To do
so, please set the temperature to lower than -20 °C.
The appliance is in operation as soon as it is connected to the power supply.
▶ The freezer temperature is automatically set to -18 °C. This is the recommended set-
ting and the ideal temperature for frozen goods. If desired, you can change the tem-
peratures manually. Please see ADJUSTING THE TEMPERATURE.
after 30 seconds. The panel lock might be active.
Notice: Presettings
▶ The appliance is preset to the recommended temperature of -18 °C. Under normal
ambient condition you don´t need to set a temperature.
▶ When the appliance is switched on after being disconnected from the main power
supply, it may take up to 12 hours for the correct temperature to be reached.
5.3 Standby-mode of display
operation. The display locks automatically. It lights up automatically when touching any but-
ton or opening the door.
5.4 Display lock and unlock
Display is automatically locked after about 30 seconds without operation.
When the display is unlocked, press “
3 Sec. Lock” (G) and hold for 3 seconds, after a beep,
indicator is light, display is locked. When the display is locked, press “3 Sec.
-
locked.
Notice: Display lock
When display is locked, functions such as temperature setting or super freeze are di-
sabled. When above operation is attempted, indicator will blink for 3 times, to
remind that the display is locked.
Lock”
3 Sec. Lock
“3 Sec. Lock”(g)
“
3 Sec. Lock”(g)
Automatic locking
Manual locking
To Next Page
