WARNING!
▶ Make sure there is no transport damage.
▶ Remove all packaging and keep out of children´s reach.
▶ Wait at least six hours before installing the appliance in order to
▶ Handle the appliance always with at least two persons because it
is heavy.
Installation
▶ The appliance should be placed in a well-ventilated place. Ensure
a space of at least 10 cm above and around the appliance.
▶ Do not cover air vent openings.
▶ Never place the appliance in a damp area or location where it
might be splashed with water. Clean and dry water splashes and
stains with a soft clean cloth.
▶ Do not install the appliance in direct sunlight or in the near of heat
sources(e.g. stoves, heaters).
▶ Install and level the appliance in an area suitable for its size and use.
▶ Keep ventilation openings in the appliance or in the in-built struc-
ture clear of obstruction.
▶ Make sure that the electrical information on the rating plate agrees
with the power supply. If it does not, contact an electrician.
▶ The appliance is operated by a 220-240 VAC/50 Hz power sup-
to start, or damage to the temperature control or compressor, or
there may be an abnormal noise when operating. In such case, an
automatic regulator shall be mounted.
▶ Use a separate earthed socket for the power supply which is ea-
sily accessible during cleaning. The appliance must be earthed.
▶
The appliance’s power cable is fitted with 3-cord (grounding) plug
▶ Do not use multi-plug adapters and extension cables.
▶ Ensure that the power cable is not trapped by the freezer. Do not
step on the power cable.
▶ Do not damage the refrigerant circuit.
hints!:
that fits a standard 3-cord (grounded) socket. Never cut off or
dismount the third pin (grounding). After the appliance is installed,
the plug should be accessible.
To Next Page
Loading...
