1
2
1
7.1
7.2
7 - Equipment
7.1 Removable door racks
The door rack can be removed for cleaning:
Place hands on each side of the rack, lift it upwards (1)
and pull it out (2) (Fig. 7.1).
In order to insert the door rack, the above steps are
carried out in reverse order.
7.2 Glass shelves
1.
edge (1) and pulling it out (2) (Fig. 7.2).
2. To reinstall it, put it on the lugs on both sides and
push it to the most rearward position until the rear
.
5.13 Error indication
This freezer is equipped with error indication. When an error is encountered, display will
could still freeze but user should contact aftersales service as soon as possible for optimal
control of the freezer.
cyclic flashing display
Energy saving tips
▶ Make sure the appliance is properly ventilated (see INSTALLATION).
▶ Do not install the appliance in direct sunlight or in the near of heat sources (e.g.
stoves, heaters).
▶ Avoid unnecessarily low temperature in the appliance. The energy consumption in-
creases the lower the temperature in the appliance is set.
▶ Allow warm food to cool down before placing it in the appliance.
▶
▶ Make sure the door always closes correctly and unimpaired by food position. Keep
door seals clean.
▶ Defreeze frozen food in a fridge.
▶
▶
Clean the rear of the appliance regularly. Dust increases energy consumption.
nd shelves to be
positioned in the appliance on factory-fresh condition, and food to be placed without
blocking the air outlet of the duct.
To Next Page
