Haier HWS60-12F2S User Manual

2929
•Yourmachinemayhaveeitherasingleinlet
(cold)ordoublewaterinlets(cold/hot)basedonits
specications.
White-cappedhoseshouldbeconnectedtocold
waterinletandred-cappedhosetohotwaterinlet
(applicableformachineswithdoublewaterinlets).
•Toeliminatewaterleakagesinpointsofcontact,
1or2nutsareprovidedinthehosepackage(ap-
plicableformachineswithdoublewaterinlets).
Fitthesenutstotheendsofnewwaterinlethoses
onthesideoffaucet.
•Mountnewwaterinlethosestoa¾˝,threaded
tap.
•Connectthewhite-elbowendofthewaterinlet
hosestothewhite-lteredwaterinletvalveonthe
rearsideofthemachineandthered-elbowendto
red-lteredone(applicableformachineswithdou-
blewaterinlets).
Tightenplasticpartsofthejunctionsusingyour
hand.
Inuncertainconditions,havetheconnectionworks
bedonebyaqualiedplumber.
•Flowofwaterwithpressureof0,1-1Mpawillal-
lowyourmachinetooperatemoreefciently.)(0,1
Mpapressuremeansthatmorethan8litresof
waterwillowthroughatapthatisturnedfullyon
peroneminute.)
•Ensurethatthepipesandallwaterconnections
donotleakbytappingthetapmovingthehoses
slightlyaftermakingtheconnections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10mm

Haier HWS60-12F2S Specifications

General

Brand	Haier
Model	HWS60-12F2S
Category	Washer
Language	English