Hakko Electronics FR-410 - Page 12

11
● Preset ID
1.
Move the cursor to select “Preset ID”. After selecting, press <ENT>.
2. Move up and down the cursor with the control buttons.
After selecting, press <ENT>.
3. Press the <↑> or <↓> to set the desired letters.
4. To exit from setting screen, scroll the screen, select <EXIT>, and press the
<ENT> button.
CAUTION
As a preset ID, 1 to 8 characters can be used.
Usable characters are “A-Z,” “0-9,” and space (“ ”). Entering a space makes your
entry terminated. Any character(s) that follows the space is deleted.
<↑> <↓> <ENT>
V acuum Check
P r ese t Temp
P r ese t I D
<↑> <↓> <ENT>
P1 I D SET
RESET1
<↑> <↓> <ENT>
P1 I D PRESET1
P2 I D PRESET2
P3 I D PRESET3
<↑> <↓> <ENT>
P2 I D PRESET2
P3 I D PRESET3
<EXIT>
12
● LCD Contrast
1.
Move the cursor to select “ LCD Contrast ”. After selecting, press <ENT>.
To make the screen display easy to see, adjust contrast.
2. Press the <↑> or <↓> to set the adjust contrast .
(Selection range is 1 to 25.)
3. Press the <ENT> button to set the value.
To exit from each setting screen, scroll the screen, select <EXIT>, and press
the <ENT> button.
<↑> <↓> <ENT>
P r ese t Temp
P r ese t I D
LCD Con tra s t
<↑> <↓> <ENT>
LCD Con tra s t
A d jus t me n t
0
<↑> <↓> <ENT>
P r ese t I D
LCD Con tra s t
<EXIT>