Hakko Electronics FR-410 - Sleep Temp; Low Temp

17
● Auto Sleep
1.
Move the cursor to select “ Auto Sleep ”.
After selecting, press <ENT>.
Select whether you will activate the auto sleep function. When the auto sleep function
is set to on and no operation is performed for constant time after the iron is set in the
iron holder, the auto sleep function will be enabled.
*
Set temp in “Sleep temp”
.
2. ON and OFF will be switched alternately
if you press the <↑> or <↓> button.
3. Selecting “ON” allows you to make the
setting for “Timer.”
(Default is 6 minutes.)
* When selecting “ON”
4. When setting “Auto Sleep” to “ON,”
the area for Timer flashes.
5. Press the <↑> or <↓> button, you can
change to the desired value.
6. Pressing the <ENT> button after this change
makes the set time stored in the internal
memory.
<↑> <↓> <ENT>
Sh u t O f f Se t
V acuumMod e
Auto S l e ep
OFF
NOR
OFF
<↑> <↓> <ENT>
 Auto S l e ep S e t
Auto S l e ep OFF
T i me r 06m
<↑> <↓> <ENT>
 Auto S l e ep S e t
Auto S l e ep ON
T i me r
6m
Select
“OFF”
Select
“ON”
<↑> <↓> <ENT>
Sh u t O f f Se t
V acuumMod e
Auto S l e ep
OFF
NOR
06m
18
● Sleep Temp
● Low Temp
1.
Move the cursor to select “ Sleep Temp ”.
After selecting, press <ENT>.
Sets the auto sleep temperature.
When the temperature drops below a set limit, an error is displayed and the buzzer
sounds.
2. Entering from hundreds to units digit.
Press the <↑> or <↓> to set the desired
figure.
Only values from 3 to 5 can be selected when
entering the hundreds digit.
(In ℃ mode, values from 2 to 3 can be
selected.)
Values from 0 to 9 can be selected when
entering the tens or units digits.
(The same values can be selected in ℃ mode.)
2. Entering from hundreds to units digit.
Press the <↑> or <↓> to set the desired
figure.
Only values from 0 to 2 can be selected when
entering the hundreds digit.
(In ℃ mode, values from 0 to 1 can be
selected.)
Values from 0 to 9 can be selected when
entering the tens or units digits.
(The same values can be selected in ℃ mode.)
3. After entering the units digit, press the button
to save the figure to the system memory
1. Move the cursor to select “ Low Temp ”.
After selecting, press <ENT>.
3. After entering the units digit, press the button
to save the figure to the system memory
<↑> <↓> <ENT>
V acuumMod e
Auto S l e ep
S l e e p Temp
NOR
06m
390ﾟ F
<↑> <↓> <ENT>
S l e e p Temp S e t
90ﾟ F
<↑> <↓> <ENT>
Auto S l e ep
S l e e p Temp
L ow Temp
06m
390ﾟ F
270ﾟ F
<↑> <↓> <ENT>
L ow Temp Se t
70ﾟ F