18
4. Offset temperature setting
5. Timer mode selection
Please refer to the
“3.
Offset temperature setting
”
in page 12.
Please refer to the
“
5. Timer mode selection
”
in page 12.
⑤ZONE 1 SET (Setting ZONE1)
⑩ZONE 6 SET (Setting ZONE6)
The hot air setting is performed. The same items can be set for each zone. First, select
whether the selected zone function will be ON or OFF.
When ON is selected, the following settings can be performed.
・When ON is selected:
Setting of the air flow
Airflow rate setting (001 to 100%)
Heating time setting (001 to 999s)Setting the Timer
RAMP RATE setting
Temperature rise rate setting ("--"*, 02 to 20℉/s)
Heating temperature setting (120 to 1120℉)
Setting the Temperature
Vacuum function ON/OFF setting (ON/OFF)Vacuum setting
〜
* When "--" is set, the ramp rate is not controlled and normal electrical power is applied.
CAUTION
If you enter a value outside the temperature setting range, the display returns to the
state of setting wait again.
⑪DEMO MODE (Read the sample data for the demo)
⑫PROFILE COPY (
Copy any profile data to another profile
)
Simple settings for the demo, which is built-in to the station will be loaded.
Copy any profile data to another profile.
3. Profile number setting
Select the place of the profile name, you can make the selection of profile No. Turn the control knob.
To Next Page
Loading...
