Hakko Electronics FR-811 - Page 8

7
Set
Date and Time
2016/01/01/00:00
● Set up the grip stand assembly.
Set up the grip stand assembly in the
figure below steps.
C. Grip stand assembly
CAUTION
When you change the orientation, please adjust as air guard does not hit the ground.
D. Electrical Connection and Power ON
CAUTION
When not in use, place the handpiece
on the grip stand assembly.
CAUTION
The HAKKO FR-811 is protected against electrostatic
discharge and must be grounded for full efficiency.
1. Connect the power cord to the power receptacle
on the back panel of the station.
2. Place the handpiece on the grip stand assembly.
3. Plug the power cord into a grounded wall socket.
4. Turn the power switch ON.
CAUTION
● Vacuum pipe
Do not use excessive force. When not using a nozzle,
retract the vacuum pipe to the shortest length.
※When you place the handpiece to the
grip stand assembly, operation
is stopped. In this case, it does not
work when you press the S button.
E. Setting Date & Time
When you first turn on the power to make the
setting of the date.
Changes values
Changes the
selected item
Enter
Set in the following operation
※Change the direction of the air guard
Change the mounting direction of the air guard.
①
②
③
Gripstandholder
Gripstandbase
Airguard