What to do if 'error' is displayed on Hakko Electronics Rework stations?
If 'error' is displayed on your Hakko Electronics Rework station, try turning the power off and then on again. If the error persists after restarting, it is recommended to request a repair.
Why does my Hakko Electronics Rework station blink?
If your Hakko Electronics Rework station blinks, make sure that the blades are fully inserted to the end. Check if the connection cord is disconnected and if the heating element is blown.
Instructions for attaching and removing the wire stripper blades.
Procedure for connecting the power cord and the FT-8004 handle to the station.
Details the function of the power switch and operation buttons, and how to interpret the display.
Provides a step-by-step guide on how to set and change the output value for wire stripping.
Presents a table outlining parameter numbers, LED displays, set details, and initial values.
Step-by-step guide on how to enter parameter input mode and set values.
Guidance on maintaining the wire stripper blades, including cleaning and suspension during use.
Procedure to check for a blown heating element by measuring resistance.
Method to verify the connection status of the unit's cord.
Step-by-step instructions for replacing the fuse in the unit.
General| Brand | Hakko Electronics |
|---|---|
| Model | FT-802 |
| Category | Tools |
| Language | English |
To Next Page
