17
First Operation
2.5.2 Error code table
In addition to the Service indicator
(wrench), a four-digit service code ap-
pears in the indicator field. The dots in
the service code flash. Clear the fault or
note down the service code and inform
your authorized Hako dealer.
Error Cause Remedy
1.2.5.2. Brush motor overload Let the brush motor cool down
1.2.6.1. Brush is blocked Remove foreign bodies
1.2.6.5. Brush semiconductor Allow the machine to cool down
or inform Hako service
1.2.6.6. Brush is not installed Install the brush
1.4.2.1. Suction turbine semiconductor Allow the machine to cool down
or inform Hako service
3.2.1.1. Invalid TSG setting Inform Hako service
4.6.1.2. Internal SE error Inform Hako service
To Next Page
Loading...
