HAKO Hakomatic B45 - Rotary Brush Head Sealing and Spray Jet Checks

57
Maintenance and Service
5.10.4 Changing the sealing strips
Check the sealing strips (Fig. 20/7)
weekly and change them as necessary.
1. Switch off the machine with the main
switch.
2. Lift out the brush head with the brush
head lift.
3. Loosen the knurled screws (Fig. 20/
9) and remove the sealing strips with
the tightening straps.
4. Assemble the new sealing strips so
that they touch the ground lightly.
Only use original spare parts!
5.10.5 Checking the spray jets
Check the spray jets daily and clean
them as necessary.
1. Switch off the machine with the main
switch.
2. Lift out the brush head with the brush
head lift.
3. Check the spray jets (Fig. 20/8) for
signs of dirt. After cleaning them, the
spray jets must produce an even
spraying pattern.
4. ver.
5.10.6 Change deflector roller
Check deflector rollers (Fig. 20/4) at
weekly intervals and replace if required.