HAKO Hakomatic B45 - Hako-System Maintenance III;S (Safety Check)

41
Maintenance and Service
Hako-System Maintenance III/S
(Safety check)
The following maintenance woks are to
be performed by an authorised Hako
Service workshop at least once yearly.
To be performed
Interval
every 500 hours of operation
Perform maintenance works according to Hako-System Maintenance II o
Check drive protection of the charger o
Check function of suction turbine and replace if required (replace at the latest after
1000 operating hours)
o
Check brake of the travel drive motor (Hakomatic B45 CL only) o
Clean travel drive motor (Hakomatic B45 CL only) from carbon dust and check car-
bon brushes for smooth operation and wearing and replace carbon brushes if
required
o
Clean brush motors from carbon dust and check carbon brushes for smooth opera-
tion and wearing and replace carbon brushes if required (replace at the latest after
1000 operating hours)
o
Test drive and function test o