5
Figure 12
Figure 11a
Figure 11b
Figure 11c
The S-ABA control arm can be placed
anywhere within the range of the bracket
slot for automatic adjustment to take
place. Haldex recommends a “common
position” for all installations, to avoid
confusion for the end-user.
Tighten all anchor bracket fasteners.
The adjuster must be manually adjusted
at this time.
Rotate the adjusting hex clockwise until
the lining lightly contacts the drum.
Back-off the adjuster by turning the
adjusting hex counter-clockwise 1/2 of a
turn (Figure 12).
A minimum of 13 ft. lbs. is necessary to
overcome the internal clutch. A ratcheting
sound will be present.
Note: Do NOT use an impact wrench
or permanent internal damage will
occur!
Note: To ensure proper fit and
function, always replace both
adjuster and mounting bracket,
as a set.
S-ABA Installation Procedures
STEP 3
STEP 4
To Next Page
Loading...