1) Roll processor forward until the feet at the end of the legs are parallel to the ground.
2) Drive to the log pile and place the feet under a log.
3) Roll the processor back to pick up the log and allow it to roll down the legs onto the splitter table.
4) Press and hold the TABLE FORWARD button to extend the splitting cylinder and splitter table
carrying the log to the splitter head.
5) Press TABLE BACK button, enabling the table to retract to the desired length of cut.
6) Press the GRAB ARM DOWN button to hold the log in position.
7) Press Splitter Back until it is all the way retracted.
8) Press and hold the SAW DOWN button to cut a piece from the log. As the cut is completed, the log
will fall into the splitter bin.
9) Release the SAW DOWN button to allow the saw to retract to its home position.
10) Press the GRAB ARM UP button to release the log.
11) Press the TABLE FORWARD button to extend the splitter. This action splits the wood while
delivering the remaining log to the splitter wedge for the next cut.
This completes one cutting and splitting cycle. Repeat this sequence until the log has
been cut and split completely.
Note: Be careful of moving skid steer with processor tilted all the way forward. This can allow
the legs to dig into the ground, and can cause damage to the legs and processor.
To Next Page
Loading...