Problem Possible Cause Solution
RPM too low Rev up motor
Bar is not getting oil See pg 10 Saw Oiler Section
OILER WILL NOT OIL:
Low oil Fill Oil
Hose to saw bar is kinked or cut Straighten or replace
Oiler is plugged Check valve
NOTHING WORKS WHEN BUTTONS ARE PUSHED:
Bad Fuse Check fuses in power plug
Frayed wire Broken wire in power plug
Bad ground Check ground wire
Flow direction is wrong Reverse direction of flow
Not getting any oil to processor Refer to skid steer manual
SAW DOES NOTHING WHEN SAW DOWN BUTTON IS PUSHED:
Limit Switch on splitter back needs Adjust Limit Switch
adjusting
OIL RESERVOIR DRAINS OUT OVERNIGHT:
Check valve stuck open Clean or replace
Oil delivery hose worn or broken Replace
SAW COMES DOWN AND CHAIN IS SPINNING BUT DOES NOT CUT:
Chain dull Sharpen or replace
Bar is rough on edges Replace bar
SAW CAVITATES OR BOUNCES WHEN CUTTING:
Not getting enough oil flow to processor Increase RPM
Warranty Transfer
The remainder of the original warranty may be transferred to the subsequent owner of the HWP- 120
only by express written consent. Please report the transfer of ownership to Halverson Wood Products
Inc. by phone at 218-587-2065 or by email.
E-mail: halversonwoodproducts@halversonwp.com
To Next Page
Loading...