Hama IR320 - Setup wizard

25
15.7 Setup wizard
You can restart the setup wizard (6.3.1. Setup wizard) at
any time by proceeding as follows:
[MENU]
System settings

Setup wizard
15.8 Info
• To have the radio display current information about
its hardware and software (version numbers, device
designation, radio ID, etc.), proceed as follows:
[MENU]
System settings

Info
• If you have already registered your radio on the online
portal of Frontier Silicon (http://www.wiradio-
frontier.com), then you can nd out the radio ID there,
as well.
15.9 Backlight
The backlight can be congured for each operating
mode (Operation Mode, Standby Mode, Slumber Mode)
separately.
• Proceed as follows:
[MENU]
System settings

Backlight
• For the operation modes Operation Mode and
Slumber mode, select between various brightness levels.
• For Standby Mode, you may also choose a brightness
level for the backlight when the radio is in standby
(Standby Level). Alternatively, you can set the backlight
to turn off completely in standby (Standby Level 
Off).
• Choose a time interval for Timeout. When the radio is in
standby, press any button other than [
] to illuminate
the display at the brightness level set for that operating
mode for the selected interval of time.
• Alternatively, you can disable this feature (Timeout 
Off).
15.10 AUX: Auto-Standby
In Aux in (Auxiliary Input) operating mode, the radio
switches to standby mode after 15 minutes, by default.
To disable (NO) or activate (YES) this feature, proceed as
follows:
[MENU]
System settings

AUX: Auto-Standby