Hameg HM8118 Operator's Manual

25
Subject to change without notice
Deutsch 3
English
Declaration of Conformity 24
Programmable LCR-Bridge HM8118 26
Specifi cations 27
Important hints 28
Symbols 28
Unpacking 28
Positioning 28
Transport 28
Storage 28
Safety instructions 28
Proper operating conditions 28
Warranty and Repair 29
Maintenance 29
Line fuse 29
Power switch 29
Controls and elements 30
First-time operation 32
Connecting the instrument 32
Turning On the HM8118 32
Setting of the line frequency 32
Storing/recalling of instrument settings
and parameters 32
Display of main and second measurement results 33
Display of measurement results 33
Measuring range 33
Measurement speed 33
Trigger source/ Trigger mode 33
Averaging 34
Setting of instrument parameters 34
Menufunction SETUP 34
Menufunction CORR 35
Menufunction SYST 35
Factory settings 36
Calibration 36
Open circuit calibration procedure 36
Short circuit calibration procedure 36
Procedure of the calibration with a known load 36
How to connect the components
and the accessories 37
Measurements with the
Programmable LCR Bridge HM8118 37
Measuring frequency 37
Measuring voltage 37
Constant voltage CST V 37
BIAS voltage/current 38
Content
Automatic/manual range selection 38
Automatic range selection 38
Manual range selection 38
Measurements using the GUARD function 39
Measurement accuracy 39
Option Handler (Sorter) Interface HO118 for
component sorting (25 p. interface) 39
Remote Control 39
1. RS-232 interface (9pin subD connector) 39
2. USB 39
USB-Driver Installation 39
Command reference 41
Measurement setup commands 41
Measurement control commands 42
Listing of commands for the request of results 42
Listing of binning commands 42
Setup and control commands 43

Hameg HM8118 Specifications

General

Brand	Hameg
Model	HM8118
Category	Measuring Instruments
Language	English