Hamilton WSA50 - Limited Warranty

To Previous Page

DISCLAIMER

The informaon contained in this guide is believed to be accurate and reliable. Hamilton

assumes no responsibility for any errors contained in this guide. Hamilton reserves the rights

to make changes in the specicaons and/or design of the above menoned product without

prior noce. The diagrams contained in this guide may also not fully represent the product that

you are using and they are for illustraon purposes only. Hamilton assumes no responsibility for

any dierences between the product menoned in this guide and the product you may have.

1. This equipment is intended for domesc and commercial use including

hotels and retail shops.

2. No decorave, abrasive or domesc cleaning products should come into contact with

the equipment (further informaon is available on request).

3. It should not be used in areas of high humidity (bathrooms etc.) nor within reach of

a water source.

4. This equipment should be connected to a mains supply of the appropriate

Voltage (indicated on the product).

5. Care should be taken not to overload the equipment maximum amperage as

indicated on the product.

6. No liability can be accepted if the product is installed or used in any other way

for which it has been designed.

Limited Warranty

1. The equipment is guaranteed against faulty workmanship or materials for a

period of twelve months and will be repaired or replaced free of charge on

condion that it is returned to the Customer Services Department and that:

i. The equipment has not been overloaded or connected to a supply other than

DC 21v 5A using the supplied power lead.

ii. The installaon procedure has been carried out correctly.

iii. The equipment has not been taken apart or repaired by any unauthorised person.

iv. The Bill of Sale (dated) accompanies the equipment for repair or replacement.

v. The product has not been exposed to decorave or cleaning materials or been

Stored or installed in areas of high humidity.

This guarantee does not aect the statutory rights of the consumer. In no circumstances can the

Company accept responsibility for any loss or damage said to arise from the use of this product. The

equipment is manufactured in accordance with the relevant Brish and European Standards where

applicable.

All products are manufactured under an accredited BS EN ISO 9001: 2015 –

Note: The WSA50 Amplier includes sophiscated protecon circuitry, designed to

ensure that it does not suer permanent damage if over-driven. The amplier will

temporarily mute sound from one or more channels if it detects an over-power

situaon on either channel. This may result in intermient audio and is a protecon

feature and not a fault, If this occurs then please reduce the volume level.