53
Other Unix Systems
To access the Internet via the Wireless Router:
• Ensure the "Gateway" field for your network card is set to the IP Address of the Wireless Router.
• Ensure your DNS (Name Server) settings are correct.
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Router's Access Point, regardless of the
operating system which is used on the client.
To use the Wireless Access Point in the Wireless Router, each Wireless Station must have compatible settings,
as follows:
Mode
The mode must be set to Infrastructure.
SSID (ESSID)
This must match the value used on the Wireless Router. The default value is Untitled
Note! The SSID is case sensitive.
WEP
By default, WEP on the Wireless Router is disabled.
• If WEP remains disabled on the Wireless Router, all stations must have WEP disabled.
• If WEP is enabled on the Wireless Router, each station must use the same settings as
the Wireless Router.
Note:
By default, the Wireless Router will allow both 802.11b and 802.11g connections.
To Next Page
