5.2 Computerfuncties / display
LEVEL:Weerstandsniveau, 1-16
Count: Tel alle slagen op tijdens je oefening
Pulse: De computer heeft een ingebouwde ontvanger, die de
hartslagfrequentie draadloos kan ontvangen. De borstriem moet
de frequentie tussen 5,0-5,5kHz gebruiken. Stel een streefhartslag
in van 60-220 spm.
RPM:Toont dehuidige rotatieper minuut
CALORIES:Toont de hoeveelheid calorieën.
Distance: Toont de afstand in meters.
TIME:Totale tijd
5.2 Computer functions / display
LEVEL:Resistance level, 1-16
Count: Accumulate all strokes during your exercise
Pulse: The computer has a build in receiver, which can receive
the heart rate frequency wireless. The chest belt should use
the frequency between 5,0-5,5kHz. Set target heartrate from
60-220 bpm.
RPM: Showingthe current rotate per minute
CALORIES:Showsthe calories amount.
Distance Shows the distance in meters.
Time: Total time.
5.1 TOETSEN:
1. ENTER
- U kunt de doelwaarden selecteren en bevestigen of het
geselecteerde programma.
2. UP/DOWN Knoppen
- Door op de +/- toetsen te drukken kunt u het programma
selecteren of de weerstand tijdens de training wijzigen.
3. PULSE RECOVERY
- Nadat u klaar bent met uw oefening drukt u op RECOVERY en stopt u
met trappen. De computer zal de hartslag meten voor de volgende 60
seconden. Als het verschil tussen de begin- en eindhartslag ongeveer
20% is, krijgt u de beoordeling F1 (zeer goed).
- Wanneer u in de pulsherstelmodus bent, drukt u op deze
toets om de modus te verlaten.
5. START/PAUSE/STOP
- Druk op de toets en het programma start. Nogmaals
drukken en het programma neemt een pauze. Nogmaals
drukken en het programma gaat door Tijdens om het even
welke modus, houd deze toets 2 seconden ingedrukt om alle
datas te resetten.
5.1 BUTTONS:
1. ENTER
- You can select and conrm the target values or the selected
program.
2. UP/DOWNButtons:
- By pressing the +/- buttons you can select the program or
change the resistance during workout.
3. PULSE RECOVERY:
- After you nished your exercise press RECOVERYandstop
pedalling.Thecomputer will measure the heartrate for the
next 60 seconds.If the dierence between the starting and
end heartrate is around 20%, you will get the grade F1 (very
good).
- When you are in pulse recovery mode, press this button to exit.
5. START/PAUSE/STOP
- Press the button and the program will start. Press again the
programm will take a break. Press again and the program
continue
During any mode, hold down this button for 2 seconds to
reset all datas.
12