EN © mPTech. All rights reserved. HAMMER CONSTRUCTION
34
In the case of phones dedicated to operators, in order to facilitate the
quickest start of using the eSIM function, a special card for this is
needed already placed in your Hammer Construction in slot No. 1 of
the tray. However, if you do not want to use the eSIM function and
your preferred configuration is, for example, to have 2 regular SIM
cards, you need to remove the eSIM card and insert one of the
standard nano SIM cards in its place.
An Internet connection (Wi-Fi or cellular data) is required to install the
eSIM profile. The smartphone should have an eSIM to connect to the
profile. Make sure it is located in the SIM slot. (It resembles a standard
SIM card).
8.1 Starting and activating the eSIM card
Go to [Settings] and select [Mobile Network/eSIM] from the menu
list (if a regular SIM card is inserted, go to [eSIM]) to start the card
installation. Activating the eSIM card involves downloading its profile
by going through the configuration.
If the SIM card is in the phone and already has an eSIM profile
assigned by the carrier, the phone will automatically download and
install this profile.
If adding a new eSIM card, remove the SIM card before
configuration!
To set up a new eSIM profile, you will need to enter a special QR code
you receive from your carrier, which you can scan with a QR code
scanner or enter manually by going to the [Need help?] tab while
scanning.
After scanning or entering the code, the card's profile will download
automatically.
Once the profile is downloaded, [Menu] > [Settings] > [Mobile
To Next Page
Loading...
