4V LITHIUM RECHARGEABLE SCREWDRIVER 7
• Charge the product indoors only as the charging adaptor is designed for indoor use only.
• Do not charge non-rechargeable batteries.
• Protect the charging adaptor against moisture and wet conditions. There is a danger of
electric shock.
• Do not place any object on top of the charging adaptor as it could cause overheating. Do
not place the charging adaptor near any heat source.
• Do not use an extension cord unless it is absolutely necessary. The use of an improper
extension cord could cause the risk of re, electric shock or electrocution.
• Do not use the charging adaptor if it has been subjected to a heavy knock, dropped or
otherwise damaged in any way. Have the charging adaptor checked and repaired by an
authorised service centre.
• Do not disassemble the charging adaptor. Incorrect re-assembly may result in the risk of
re, electric shock or electrocution.
• Disconnect the charging adaptor from the power supply before attempting to clean it to
reduce the risk of an electric shock.
NOISE/VIBRATION INFORMATION
Wear hearing protection!
The following information:
- That the declared vibration total value has been measured in accordance with a standard
test method and may be used for comparing one tool with another;
- That the declared vibration total value may also be used in a preliminary assessment of
exposure.
A warning:
- That the vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used; and
- Of the need to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched off and when it is running idle
in addition to the trigger time).
To Next Page
Loading...
