8
Assembly - Hanging the Fan
Attaching the fan to the electrical
box
Hanging the fan
□ Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□ Install the ceiling mounting bracket on the outlet box by slid-
ing the slide-on mounting bracket (A) over the two screws (UU)
provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and the
outlet box. Note that the at side of the mounting bracket (A) is
toward the outlet box.
□ Securely tighten the two mounting screws (UU).
□ Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball.
4 5
WARNING: To reduce the risk of re, electric shock or
personal injury, mount to outlet box marked “acceptable
for fan support of 35lbs. (15.9 Kg) or less” and use screws
provided with the outlet box.
A
UU
UU
D
E
A
B
C
To Next Page
Loading...
