HAMPTON BAY MORLAND 59080 - Table of Contents; Safety Information

2
1. To reduce the risk of electric shock, ensure the electricity has
been turned off at the circuit breaker or fuse box before you
begin.
2. All wiring must be in accordance with the National Electrical
Code ANSI/NFPA 70 and local electrical codes. Electrical
installation should be performed by a qualied licensed
electrician.
3. The outlet box and support structure must be securely mounted
and capable of reliably supporting a minimum of 35 lb (15.9
kg). Use only UL Listed outlet boxes marked “Acceptable for Fan
Support of 35 lb (15.9 kg) or less.”
4. The fan must be mounted with a minimum of 7 ft. (2.1 m) of
clearance from the trailing edge of the blades to the oor.
5. Do not place objects in the path of the blades.
6. To avoid personal injury or damage to the fan and other items,
use caution when working around or cleaning the fan.
7. After making electrical connections, spliced conductors should
be turned upward and pushed carefully up into the outlet box.
The wires should be spread apart with the grounded conductor
and the equipment-grounding conductor on one side of the
outlet box.
8. All set screws must be checked and retightened where
necessary before installation.
9. Suitable for damp location.
10. Use only with light kits marked Suitable for use in damp
locations.
READ AND SAVE THESE INSTRUCTIONS.
Safety Information ....................................2
Warranty ............................................2
Pre-Installation .......................................3
Planning Installation .................................3
Tools Required ......................................3
Hardware Included ...................................4
Installation ..........................................6
Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Care and Cleaning ...................................20
Troubleshooting .....................................20
Table of Contents
WARNING: To reduce the risk of personal injury, do not
bend the blade brackets (also referred to as anges) during
assembly or after installation. Do not insert objects in the
path of the blades.
WARNING: Electrical diagrams are for reference only. If
you are using a light kit, refer to the light kit instructions
manual to make the electrical connections. Optional use of
any light kit shall be UL Listed and marked suitable for use
with this fan.
WARNING: To avoid possible electrical shock, turn the
electricity off at the main fuse box before wiring. If you feel
you do not have enough electrical wiring knowledge or
experience, contact a licensed electrician.
WARNING: To reduce the risk of re, electric shock or
personal injury, mount to outlet box marked “Acceptable
for fan support of 35 lbs (15.9 kg) or less”, and use screws
provided with the outlet box.
WARNING: To reduce the risk of re or electric shock,
this fan should only be used with fan speed control part
no. LDDP40-L3620, manufactured by DawnSun Electronic
Technology Co., Ltd. Zhongshan.
WARNING:To reduce the risk of electric shock, this fan
must be installed with an isolating wall switch.
WARNING: To reduce the risk of re, electric shock or
injury to persons, do not use replacement parts that have
not been recommended by the manufacturer (e.g. parts
made at home using a 3D printer).
Safety Information