7
HOMEDEPOT.COM/HUBSPACE
1-877-592-5233
Preparing for mounting
□ Remove the magnetic canopy bottom cover (JJ) from the
canopy (C) by pulling it off.
□ Loosen the two canopy screws (SS) located in the bottom
of the slide-on mounting bracket (A).
□ Turn the slide-on mounting bracket (A) counterclockwise
and lift it up to remove the slide-on mounting bracket from
the canopy (C).
2
NOTE: The magnet is pre-attached on the canopy
bottom cover for you to remove and install easily.
A
C
JJ
SS
Installing with an Extension Downrod
(sold separately)
□ Disassemble the hanger ball from the downrod by
removing the set screw (MM) slide the hanger ball down
the downrod and remove the pin (OO),keep parts.
□ Place the hanger ball on the new downrod and insert the
in (OO) through the holes at top of downrod and slide the
hanger ball up to the downrod until the pin (OO) locked into
the slots of hanger ball.
□ Re-install the set screw (MM) tighten it so the set screw is
secured against the downrod.
Assembly - Standard Ceililng Mount
1
OO
B
MM
OO
B
To Next Page
Loading...
