Hamron 001-200 User Manual

EN
34
TECHNICAL DATA
Rated voltage 230 V
~
50 Hz
Fuse 16 A
Output 2500 W
Safety class II
Protection rating IPX5
Rated pressure 130 bar/13 MPa
Max pressure 170 bar/17 MPa
Rated ow 7.3 l/min
Max ow 7.8 l/min
Max inlet pressure 7 bar/0.7 MPa
Hose length 8 m
Cord length 5 m
Dimensions 35 x 90 x 39 cm
Weight 22.4 kg
Sound pressure level, LpA 69 dB(A), K = 3 dB
Measured sound power level, LwA
86 dB(A), K = 3 dB
Guaranteed sound power level, LwA
86 dB(A), K = 3 dB
Vibration 10 m/s², K = 1.5 m/s²
Always wear ear protection.
The declared vibration value, which has been
measured by a standardised test method, can be
used to compare dierent tools with each other
and for a preliminary assessment of exposure.
WARNING!
The actual vibration level when using power
tools may dier from the specied maximum
value, depending on how the tool is used. It is
therefore necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched o and when it is idling, in
addition to the start-up time).
DESCRIPTION
FIG. 1
1. Trigger
2. Transport handle
3. Power switch
4. Cord retainer
5. Chemical switch
6. Power cord
7. Front
8. Inlet, water
9. Wheel
10. High-pressure hose
11. Hose retractor
12. Nozzle
13. Spray gun holder
14. Spray nozzle holder
15. Spray head
16. Chemical container
17. Back
18. Guard for spray nozzle
ASSEMBLY
The two supplied screws are used for the
assembly.
1. Press the spray gun holder in place.
FIG. 2
2. Fit the spray head guard by rst pressing
the tab in the slot on the bottom left of the
appliance, and then locking the guard in
place with the small screw.
FIG. 3
3. Fit the spray head. Fit the spray head in the
spray gun and twist to lock in place.
FIG. 4

Hamron 001-200 Specifications

General

Brand	Hamron
Model	001-200
Category	Pressure Washer
Language	English