Hamron 001-200 User Manual

EN
37
10. Place both spray heads in the storage
position. Place the large spray head with
the nozzle down.
11. Wind up the high-pressure hose on the
hose reel.
12. Place the hose in the space for accessories.
NOTE:
• After using the high-pressure washer hot
water can run out when the inlet hose or
high-pressure hose are disconnected.
• Disconnect the water supply from the
high-pressure washer.
MAINTENANCE
• Store the high-pressure washer, its parts
and accessories, out of the reach of
children. A suitable storage temperature is
from 10 – 30°C. Do not expose the
high-pressure washer to frost – risk of freeze
damage.
• Store the high-pressure washer in the pack,
or otherwise protected from dust.
Frost protection
1. Empty any water in the high-pressure
washer and all the accessories to avoid the
risk of freezing.
2. Disconnect the water supply from the high-
pressure washer.
3. Remove the spray head from the spray gun.
4. Start the high-pressure washer with the
power switch.
5. Press the trigger until no more water comes
through the nozzle.
6. Release the trigger.
7. Lock the spray gun with the catch.
8. Switch o the high-pressure washer with
the power switch.
9. Store the high-pressure washer and all
accessories frost-free.
High-pressure hose
• Handle and store the high-pressure hose
with care, its reinforcement is easily
damaged.
• Do not bend or clench the hose.
• Avoid treading or driving over the hose.
• Keep the hose away from heat, oil and
sharp edges.
Inlet lter
• Clean the inlet lter regularly.
• Remove the connector from the water inlet
and rinse with hot water to avoid blocking
the pump.
• Clean the nozzle with the supplied tool.
Release the spray head from the spray gun.
Remove any impurities from the nozzle and
rinse clean.
NOTE:
• Be careful not to damage the lter.
• Pull out the lter with at pliers.
• Clean the lter under running water.
• Replace the lter in the water inlet.
Transport
NOTE:
• Risk of personal injury and/or material
damage.
• Take the weight of the appliance into
consideration when transporting.
Transporting by hand
• Switch o the high-pressure washer,
disconnect the water supply and pull out
the plug.
• Pull out the transport handle until it locks
in place. Use transport protection where
appropriate.
• Tilt the high-pressure washer towards you
so that it balances on the wheels and move
it by using the transport handle.
• Always hold the high-pressure washer by
the transport handle.

Hamron 001-200 Specifications

General

Brand	Hamron
Model	001-200
Category	Pressure Washer
Language	English