EN
36
• Check that the power switch is in the OFF
position before plugging in the plug.
• Place the appliance on a level, stable
surface when in use.
1. Connect the water supply and plug in the
plug according to the instructions.
2. Open the water tap.
3. Put the power switch in the ON position.
4. Hold the spray gun rmly with both hands.
5. Point the nozzle at the surface to be cleaned.
6. Unlock the trigger and press until a
continuous jet ows through the nozzle and
brings with it any air from the hose.
7. Release the trigger to stop the jet, and
switch o the appliance. The high pressure
remains in the appliance.
High/low pressure mode
High-pressure and low-pressure mode is selected
by pulling the nozzle forwards or backwards.
High-pressure mode – nozzle in back position.
Low-pressure mode – nozzle in forward position.
FIG. 8
Adjusting the water jet
Adjust the water jet from the nozzle by turning
the nozzle clockwise/anticlockwise.
FIG. 9
Using detergent
NOTE:
• Detergent can only be added when the
nozzle is in low-pressure mode (forward
position).
• Follow the instructions on the safety
information sheet for the actual
detergent, in particular the instructions
concerning personal safety equipment.
1. Remove the lid from the chemical
container.
2. Carefully pull out the chemical container
from the high-pressure washer.
3. Fill the container with detergent. Only use
detergent intended for the high-pressure
washer.
4. Insert the hose is the chemical container
and press down the lid.
5. Spray the detergent thinly on the dry
surface and allow to act, but not to dry.
6. The amount of detergent can be adjusted
between min and max with the knob.
FIG. 10
7. Hose o the detergent and dirt in high-
pressure mode.
During a pause in the work
1. Release the trigger.
2. Lock the spray gun.
3. Put the spray gun with the spray head in
the storage position.
4. Switch o the high-pressure washer if it is
not going to be used for 5 minutes or more.
After nishing the work
1. Release the trigger.
2. Switch o the high-pressure washer with
the power switch.
3. Pull out the plug.
4. Release the pressure from the high-pressure
washer before removing the pressure hose
from the spray gun or the washer.
5. Close the water tap.
6. Press the trigger to release any residual
pressure in the system.
7. Release the trigger.
8. Lock the spray gun with the catch.
9. Place the spray gun in the storage position.
To Next Page
Loading...
Need help?
General
