EN
35
4. Connect the high-pressure hose to the
spray gun. Connect the high-pressure hose
coupling to the spray gun and lock by
tightening the nut.
FIG. 5
5. Connect the water hose to the water inlet
on the high-pressure washer and connect
the water hose to the hose coupling.
FIG. 6
USE
Intended use
• The high-pressure washer is only intended
for household use.
• If the high-pressure washer is connected to
the drinking water supply it must be tted
with a suitable check valve.
• Take into consideration the nominal
incoming maximum ow for the high-
pressure washer.
• The high-pressure washer is intended for
cleaning vehicles, buildings, terraces and
walls etc. with clean water, where
appropriate with the addition of
biodegradable detergent. It can also be
used to clean paving and rain gutters.
NOTE:
• The appliance must only be connected to
a mains outlet with a 16 A fuse.
• The minimum hose dimension is 1/2” (13
mm).
• The hose must be reinforced.
• The incoming water ow must be at least
the same as the maximum ow for the
high-pressure washer.
• Do not run the high-pressure washer
without liquid for more than two minutes,
this will damage the high-pressure pump.
If the pressure is not suciently high
within two minutes, switch of the
high-pressure washer and follow the
instructions in the troubleshooting table.
Overload protection
The overload protection switches o the high-
pressure washer in the event of high power
consumption.
Starting the high-pressure washer
1. Place the high-pressure washer on a level
and stable surface.
2. Plug in the plug.
3. Connect the water supply.
4. Put the power switch in the ON position.
FIG. 7
Venting the high-pressure washer
Vent the high-pressure washer as follows before
use:
1. Start the high-pressure washer with the
power switch.
2. Release the spray gun with the catch.
3. Press the trigger. The high-pressure washer
starts working.
4. Allow the high-pressure washer to run until
water without bubbles comes out through
the nozzle.
5. Release the trigger.
6. Lock the spray gun with the catch.
NOTE:
When venting, do not run the high-pressure
washer for more than two minutes.
High-pressure washing
NOTE:
• Hold the nozzle at least 30 cm from
painted surfaces when cleaning to avoid
damage.
To Next Page
Loading...
Need help?
General
