ELEKTRA 2000 Hamtronix
12
25 – SIMPLEX REPEATER (Default = 0)
Do not require separate receiver and transmitter. Even an HT can be used for this. When enabled, any
incoming signal will be recorded and played back. The duration of each transmission should not exceed
20s or it will be cropped. Due to its low cost, can be invaluable for emergency and expedition purposes.
2 Enable with courtesy tone
Note: As use the space for voice message ID, all prior contents will be lost. Function 38 must be disabled
in order to use this function.
26 – REPEATER TIME-OUT (Default = 6)
Determines the maximum allowed time for each transmission. 10 seconds before the time is up, a short
beep will indicate that the time-out time has almost been reached. After time-out, a melody will be heard
and the transmitter may or may not drop depending on the setting of function 09. If dropped, will remain
that way until the COR that caused the time-out is dropped.
Note: The timer counter is reset at courtesy tone. If the signal that caused the time-out drop is still on
the receiver holding the transmitter keyed, you can send * to bring it back(your signal must be stronger
in order to gain control).
27 ~ 32 – REMOTE OUTPUTS 1 ~ 6 (Default = 0)
6 remote outputs are available for general purpose use.
2 Pulse (inverts state for 100 ms)
Example: To enable output 5 press: 1234311#
Note: These outputs are CMOS logic and can drive a maximum of 10mA each. If you need to interface
with a relay, use a transistor as a buffer.
33 – REPEATER DTMF CONTROL ENABLE (Default = 1)
You can disable the repeater port from accepting DTMF commands when the link port is up and you can
control it by another frequency on the link port.
Note: You can’t enable this function if the link port is down.
34 - DTMF MUTE ENABLE (Default = 0)
When enabled, anytime a DTMF tone is received, the audio will be muted to the Repeater's transmitter.
The transmit audio will remain muted for 2s after the last DTMF tone is received. This feature prevents
control commands from being repeated. It provides an extra measure of security. There may be times
when it is desirable to pass the DTMF tones through the repeater and you can disable this function.
Note: Do not use excessive levels at RX-1 trim pot because saturated audio with high tone voices may
fool the DTMF decoder and cause an undesirable mute over a voice communication.
35 – PASSAWORD SETUP (Default = 1234)
To change the password.
If the actual password is 1234 and you want 5678 press: 123435#56785678#
Note: The new password is entered twice for security purposes.
To Next Page
Loading...
General