ELEKTRA 2000 Hamtronix
8
FUNCTION DESCRIPTION
01 – REPEATER TRANSMITTER ENABLE (Default = 1)
This is the master repeater switch. This function must be enabled for normal repeater operation. The
Elektra 2000 will continue to respond to DTMF commands even when the repeater's transmitter is
disabled. This function will automatically be enabled after a reset or power up.
0 Disable 1 Enable
02 – TRANSMITTER HANG TIME (Default = 4)
When not zero, the repeater's transmitter will remain on the air for a selected period of time before the it
drops.
Note: This time must be greater than the sum of the time for courtesy tone and it’s duration or the
courtesy tone will be missed.
03 – TIMER TO COURTESY TONE (Default = 2)
This function determines the delay after COR is lost until the courtesy tone occurs.
Note: This time must be less than the sum of hang time and courtesy tone duration or the courtesy tone
will be missed.
04 – DURATION OF COURTESY TONE (Default = 1)
Determine the duration of courtesy tone.
Note: This function only affects the simple courtesy tone (see function 06). The duration of multi
courtesy tones are not controlled by user, they are pre-determined by the firmware.
05 – COURTESY TONE FREQUENCY (Default = 2)
Determine the frequency of courtesy tone.
Note: This function only act for simple courtesy tone (see function 06). The frequency of multi courtesy
tones are not controlled by user, they are pre-determined by the firmware.
06 – COURTESY TONE SELECTION (Default = 0)
Determine the type of courtesy tone. Only the simple tone may have it’s frequency and duration modified
(See function 04 and 05 for details).
1 Courtesy Tone Editor (See Function 43)
To Next Page
Loading...
General