What does 'Left Lamp Short' mean on my Handicare Puma 20 Wheelchair and what should I do?
A 'Left Lamp Short' means the control system has detected a short in either of the Lamp Circuits. Check the lamps, cables, and connections to the control system. If the error persists, the ISM may be defective.
What does 'Brake Lamp Short' mean on my Handicare Puma 20 Wheelchair and how do I fix it?
A 'Brake Lamp Short' means the control system has detected a short in the Brake Lamp Circuit. Check the brake lamps, cables, and connections to the control system. If the error persists, the ISM may be defective.
What does 'PM Memory Error' mean on my Handicare Puma 20 Wheelchair?
A 'PM Memory Error' is a specific Power Module based trip. Check all cables and connections. Using the R-net PC Programmer, re-program the control system with either the most current specific program file for the wheelchair or the manufacturer's original programming file. If the error persists, the PM may be defective.
What does 'Bad Settings' mean on my Handicare Puma 20 and how can I correct them?
A 'Bad Settings' error indicates that the control system has detected incorrect or invalid program settings. Check all parameter settings and re-program the control system using the R-net PC Programmer. Make a note of the current parameter settings and then reset the control system to default settings. Re-program the required settings in small groups, cycling the power after each group to see if the error occurs. If the error persists, the PM may be defective.
What does 'Latched Timeout' mean on my Handicare Puma 20 Wheelchair and how can I fix it?
A 'Latched Timeout' error means the control system has detected that the programmed Latched Timeout time has been exceeded. Cycle the power and initiate Latched Mode. If the error persists, the Input Device may be defective.
What does 'Inhibit Active' mean on my Handicare Puma 20 Wheelchair and how do I resolve it?
An 'Inhibit Active' error means that one of the Inhibit inputs is active and in a latched state. Cycle the power, which will drop out of Latched Mode and might clear the error. Check all wiring and switches connected to the indicated Inhibits. If the error persists, the ISM may be defective.
What does it mean when the service indicator flashes once on Handicare Puma 20 Wheelchair?
This is likely a 'STALL' timeout caused by user error. Place the joystick in neutral and try again.
What does 'System Error' mean on my Handicare Wheelchair and how can I fix it?
A 'System Error' indicates a fault that cannot be attributed to a specific module. Check all cables and connections. Cycle the power. If the error persists and the system contains 3rd party Modules: Disconnect all the none PGDT modules and cycle the power. If this has cleared the trip: Connect each 3rd party module in turn, cycling the power each time. If the trip reappears after one of the power cycles then the last module to have been added to the system must be defective. If the error persists, the PGDT control system may be defective.
What does it mean if ON/OFF light flashes 5 times on Handicare Mobility Aid?
General| Type | Power Wheelchair |
|---|---|
| Foldable | No |
| Footrests | Yes |
| Seat Width | 40-48 cm |
| Seat Depth | 40-48 cm |
| Backrest Height | 40-50 cm |
To Next Page
