Handlink Technologies WG-500P - Printing a Test Page

WG‐500PHotspotinaPrinter
8

z UPLINKLED:
Off:Aporthasnotestablishedanynetworkconnection.
Yellow light: A port has established a valid 10/100 Mbps network
connection.
YellowBlinking:10/100Mbpstrafficistraversingtheport.
z Reset Button: The WG‐500P has a reset button at the rear panel of the
device.Usethisfunctiontoresetthesystembacktofactorydefaults.
z PowerJack:UsedtoconnecttheexternalpowersupplywiththeWG‐500P.



141 Printingatestpage
Afteryouhaveinstalledyourprinter,youshouldprintatestpagetomakesurethe
printerisfunctioningproperly.Todothisactasfollows:
1. Turntheprinteroff.
2. HolddownthebuttonAforapproximatelyfiveseconds,andthenturnthe
printeron.
3. Theprinterwillprintatestpage.
