Easy Hotspot Kit
44
Item Default Description
NTP Setting Disable
Enables or disables NTP (Network Time Protocol)
Time Server. Network Time Protocol can be utilized to
synchronize the time on devices across a network. A
NTP Time Server is utilized to obtain the correct time
from a time source and adjust the local time.
Server IP/Domain Name Empty
Enter the IP address/domain name of NTP server. The
maximum allowed characters length is 100.
Time Zone GMT-12:00 Select the appropriate time zone for your location.
Update Time 0 hours Enter the number of hours for update time.
Disable Enables or disables Daylight Saving Time (DST).
Daylight Saving Time
Month/Day
Set the Daylight Saving Time (DST) on the Wireless
Subscriber Gateway. Adjust the begin time and end
time.
NAT (Network Address Translation)
NAT Enable Enables or disables NAT Address Translation function.
User Session Limited Enable,30
Enables or disables user session limit function. This
feature provides you an ability to control a number of
sessions allowed for particulars user(s) at the one
time.
IP Plug and Play (iPnP
Technology)
Enable
Enables or disables plug & play function. When
enabled, the user needn’t change their network
configuration to access the Internet.
Layer 2 Isolation Security Enable
If enable plug and play is selected, you can enable
Layer 2 Isolation Security function. When the “Layer 2
Isolation Security” enabled, everyone cannot
communicate with each other.
Secure administrator IP
Addresses
Any
Options: Any and Specify. Administrator can specify 5
IP addresses or a range to allow remote control access
from network.
Multicast Pass Through Disable
This function allows for multiple transmissions to
specific recipients at same time.
Allow remote user to ping the
device
Enable
This function allows remote user to ping the Wireless
Subscriber Gateway through Internet. Ping is normally
used to test the physical connection between two
devices, to ensure that everything is working correctly.
To Next Page
Loading...