67
9.Daily Maintenance
The earnest complete maintenance, can keep
the forklift to be at the good status. And the
safety of the truck is related with your job and
your life.
WARNING
Except checking lights and
operating capability, you should
shut off the key switch and pull out
the plug before checking electric
system.
Prohibit operate forklift with trouble.
Little trouble brings big accident.
1. Inspect oil leakage: include hydraulic oil,
electrolyte and brake fluid
Inspect connector of the oil pipe and storage
battery to see whether there is any leakage.
Use your hand or eyes to inspect, Forbid to
use a flame.
2. Inspect tire
Turn the tire valve cap counter clock-wise and
move it. Using a tire pressure gauge, measure
the inflation pressure, and adjusting it to the
specified pressure, if needed. After making
sure there is no air leakage from the tire valve,
reinstall the cap. Check that each tire does not
get damaged at the tread surface or side face.
Make sure the wheel felloe is not bended.
WARNING
Since the tires of forklift truck need
have a high inflation pressure to
carry heavy loads, even a small
bending of rims or a little damage at
the tread surface could cause an
accident.
When using an air compressor, at
first, adjust the air pressure of the
compressor. Otherwise it will cause
a serious accident, since the
maximum pressure of compressor
higher than the pressure tire can
bear.
Tire Pressure
Only for the pneumatic-tire(GB/T2982-2001)
Replace tire
Warning
• When using an air compressor, first
adjust the air pressure of the compressor.
Failure to do so will cause a serious
accident, since the compressor delivers the
maximum pressure.
• To ensure safety, put the tire in a
defend casing while inflating.
Front wheel
①Park forklift truck on level concrete;
② Start engine and raise mast about
100mm height.
③ Place chocks behind rear wheels to
prevent movement of forklift;
④ Loosen wheel nuts 1-2 turns each by
turning them counter-clockwise;
⑤ Tilt mast fully backward, and place a
To Next Page