14
Replace the battery cover making sure that the gasket is
in place.
Replace the three 1.5V AAA alkaline batteries located in
the battery compartment, observing the indicated polarity.
BATTERY REPLACEMENT
When the remaining battery life is less
than 10% the battery tag blinks on the
display to warn the user.
Battery Error Prevention System (BEPS)
If the battery is too weak (“0%”) the display shows “bAtt“,
“DEAD“ for a few seconds then the meter powers off.
Immediately replace the batteries with new ones.
The batteries are accessed by opening the battery cover
on the back of the instrument. Remove protective boot
if present.
BATTERY REPLACEMENT
Change the standard, clean the electrode or press any key
to exit calibration. After the calibration procedure has been
completed, the tag is turned on.
To Next Page
Loading...
Need help?
General
