11
DISPLAY DESCRIPTION
1) Battery icon. When the instrument is powered by batteries, at the start of the instrument, the
remaining battery life is displayed along with the battery icon. When blinking, the batteries
are almost empty and need to be replaced.
2) Wait icon. It is displayed along with the timer countdown in colorimeter range.
3) Measurement icon. The icon shows the measuring scheme of the instrument.
4) Lamp icon. The lamp icon is shown when the lamp is turned on.
5) Four digit main display. The main display shows the measured value after one measurement.
Depending on the instrument working mode, other values or messages are displayed.
6) Measurement units. The turbidity is measured in NTU. When average mode or continuous
mode is selected, the NTU tag blinks at each new displayed value. For conversions in other
units see “Measurement Units” section on page 7. Free & Total Chlorine are measured in
mg/L; % is used to display the remaining batteries life.
7) AVG icon. When selected, in turbidimeter range only, the measurement will be made in
average mode. The NTU tag blinks at each new displayed value.
8) Four digit secondary display. The secondary display shows the current time (if selected), if
not selected “turb”, “F Cl” or “t Cl” is displayed indicating the momentarely range. It can
display other values/messages.
BEEPER
A beeper is used to make the user interface more friendly. An error or invalid key press is
signaled by a long beep. A confirmation beep is signaled by a short beep. The beeper is
selectable as ON or OFF in SETUP menu.
To Next Page
Loading...
Need help?
General
