45
Data transmission from the instrument to the PC can be done with the
HI92000 Windows
®
compatible software (optional). HI92000 also
offers graphing and an on‑line help feature.
To allow our users access to the latest version of Hanna Instruments
PC compatible software, we made the products available for download
at http://software.hannainst.com. Select the product code and click
Download Now. After download is complete, use the setup.exe file to
install the software.
Data can be exported to the most popular spreadsheet programs for
further analysis. To connect your instrument to a PC, use a standard
USB cable connector. Make sure that your instrument is switched off
and plug one connector to the instrument’s USB socket and the other to
the USB port of your PC.
Note: If you are not using Hanna Instruments HI92000 software,
please see the following instructions.
SENDING COMMANDS FROM PC
It is also possible to remotely control the instrument with any terminal
program. Use a standard USB cable to connect the instrument to a PC,
start the terminal program and set the communication options as follows:
8, N, 1, no flow control, 9600 baud rate.
COMMAND TYPES
To send a command to the instrument the scheme is:
<command prefix> <command> <CR>
where: <command prefix> is a selectable ASCII character
between 0 and 47.
<command> is the command code (3 characters).
Note: Either small or capital letters can be used.
SIMPLE COMMANDS
RNG Is equivalent to pressing RANGE
CAL Is equivalent to pressing CAL
CFM Is equivalent to pressing CFM
UPC Is equivalent to pressing the UP arrow key
DWC Is equivalent to pressing the DOWN arrow key
SET Is equivalent to pressing SETUP
LOG Is equivalent to pressing LOG
MOD Is equivalent to pressing MODE
GLP Is equivalent to pressing GLP
RCL Is equivalent to pressing RCL
PC INTERFACE
To Next Page
Loading...
Need help?
General
