Hanna Instruments HI9829 - CHAPTER 6 - PARAMETER SETUP MENU; SELECT PARAMETERS; PARAMETER UNITS

31
Chapter 6 - PARAMETER SETUP MENU
From the main menu, use the / keys to highlight “Param‑
eter Setup” and then press <Select>.
The following options will be displayed:
Use the / keys to scroll through the menu. Press the
right softkey to enable or disable a single parameter, or the
left softkey to enable or disable all parameters. A checked box
means that the parameter is enabled.
Only the available parameters are present in the list.
Note: If the password protection is enabled, you will
be required to enter the password before any parameters can be modified.
Temperature Unit
The user can select the measurement unit: °C, °F or K. The
default value is °C.
TDS Unit
The user can select ppm ‑ ppt or mg/L ‑ g/L measurement
unit. The default value is ppm ‑ ppt.
DO Concentration Unit
The user can select ppm or mg/L. Dissolved Oxygen concen‑
tration is calculated using % saturation, conductivity and
atmospheric pressure. The default value is ppm.
Pressure Unit
The user can select one the following measurement units:
psi, mmHg, inHg, mbar, atm, kPa. The default value is psi.
SELECT PARAMETERS PARAMETER UNITS