Hansa C4 - Shutdown Procedure; Petrol

Hansa C4 O&M Manual - OM-005 Revision F 20/06/2019
© Hansa Chippers 2019
9
Petrol
The chipper requires 91 unleaded
or E10 petrol to run; check the
petrol level before starting.
Pull the pull cord in one smooth
motion to start the engine.
Once the engine is started and has
warmed up (approx. 10 seconds),
turn the choke lever to the “off”
position (as shown in the picture).
Shutdown procedure
Turn the throttle lever to the “min”
position.
Turn the engine switch to the “off”
position.
3
4
1
2
Throttle
lever (“min”
position)
Pull cord