Hansa C4 - Belt Replacement Procedure; Steps for Belt Change

Hansa C4 O&M Manual - OM-005 Revision F 20/06/2019
© Hansa Chippers 2019
18
If a belt change is necessary, follow these steps
Using a 6 mm Allen key, undo the two cap screws from
the belt guard and then remove the belt guard.
Using two 13 mm spanners, unbolt and remove the
engine (4 x M8 Nuts). Replace the belt (A21 vee belt).
Replace the engine and do the fasteners back up.
Check the pulleys are still in line by placing a straight-
edge across the top and bottom front pulley.
Follow the ‘adjusting belt tension’ procedure on page 16
1
2
3
4
5