EasyManuals Logo

Hansen P4 QVR.2 Series User Manual

Default Icon
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
... during start up
... during normal operation
6
ENGLISH
Take care of...
Check the internal components of the gear
unit for corrosion.
Possible damage if neglected
Damage to gears and bearings
Fill gear unit up to correct level.
Use required oil and correct viscosity.
Oil level too low -> damage to gears and
bearings
Oil level too high -> leakage, increased oil
tem
p
erature
Viscosity too high (thick oil) -
> lubrication is
unsatisfactory with very low starting
temperature.
Viscosity too low (very fluid oil) -> too thin
oil film: bearing damage and pitting or
scuffing on gears
Use clean oil and fill oil trough prefiltered
unit (avoid abrasive particles and water).
Correct tightening of fixation bolts
Retorque after 50 to 100 hours of first
o
p
eration.
Abrasive wear of bearings and gears due to
foreign particles in oil
Loosening of bolts and displacement of
the gear unit -> misalignment -> ...
Correct functioning of control equipment
Install and connect correctly lubrication group
and control switches.
No alarm in case of malfunctioning
Damage to bearings and gears
No lubrication -> damage to gears and
bearings.
Check the direction of rotation of the low
speed shaft (built in backstop): refer to the
dimensional drawing.
Wrong direction of rotation -> damage to
the backstop and other parts
Take care of...
First oil change after 100 hours, max 800
hours to take out small wear particles due to
running in.
Possible dama
g
e if ne
g
lected
Premature damage to gears and bearings
(Final impact - long term effect)
Regular oil change when oil has lost its
lubrication capacity.
Avoid enterin
g
of sand, water, cement,...
If oil has lost its capacities, anti-scuffing and
anti corrosion are unsatisfactory ->
damage to gears and bearings
Dama
g
e to
g
ears and bearin
g
s
Check breather. Obstructed breather -> leakages
-> too low oil level
-> damage to bearings and gears.
Note: This quick reference for handling the gear unit is not exhaustive.
The obligation to read the complete service manual remains.
5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hansen P4 QVR.2 Series and is the answer not in the manual?

Hansen P4 QVR.2 Series Specifications

General IconGeneral
BrandHansen
ModelP4 QVR.2 Series
CategoryDC Drives
LanguageEnglish

Related product manuals