1. SCOPE
This service manual contains the storage, installation, operating, lubrication and maintenance instructions for the
Hansen P4 standardized gear units.
The Hansen P4 gear unit is a component of a machine to decrease or to increase the input speed and
respectively to increase or to decrease the transmitted torque.
Additional information can be obtained by contacting one of the Hansen Industrial Transmissions nv sales centres
worldwide (p. 2).
All handling, storage, installation, start-up, inspection and maintenance of the equipment shall be
done by personnel qualified in matters of industrial mechanical and - where applicable - electrical
equipment.
2. GENERAL
2.1. GENERAL INSTRUCTIONS
Carefully read this manual before installing the gear unit.
Compliance with the instructions is required for long and troublefree operation of the gear unit.
The equipment should be checked against shipping papers and inspected for apparent damage caused during
transport. Any shortage, discrepancy or damage must immediately be reported to Hansen Industrial
Transmissions nv.
2.1.1. Warranty
The warranty clause of the "General Conditions of Sale" applies to gear units installed and maintained as per
instructions contained in this manual and in any additional instruction leaflets supplied with the gear unit insofar
as the gear unit operates within the service and rating conditions put forward in the "Order Acknowledgement"
and on the certified drawings.
Non compliance with these instructions, injudicious choice of lubricant or a lack of maintenance will render
warranty agreement invalid.
This warranty clause applies to all parts of the gear unit with the exception of these parts which are subject to
wear.
2.1.2. Security
Before starting activities it is essential to consult and study attentively the certified drawing of the gear
unit.
The certified drawing contains the information which makes it possible to work in safe conditions and
to avoid risks, damage and injury.
2.1.2.1. Application
It is not allowed to use the gear unit for other applications or in other operating conditions than those for which it
was ordered.
The application, the operating conditions and the conditions of use are described in the "Order
Acknowledgement".
In the absence of information or in case of doubt, refer to Hansen Industrial Transmissions nv.
2.1.2.2. Storage and packing
Read carefully the chapters “Shipping” and “Storage” to follow up the necessary instructions.
To protect the gear units from corrosion, they are treated with anti-corrosive products.
It is strongly recommended to carry out the unpacking and the inspection in a roomy, dry and aired workshop.
ENGLISH
8
7
To Next Page
Loading...
Need help?
General
