Hansen P4 Series User Manual

14. LUBRICANTS
14.2. POLYALPHA-OLEFINE BASED SYNTHETIC OILS AND SUITABLE GREASE
For Hansen P4 standardized gear units
Unless indicated otherwise on the gear unit's name plate, the oils and lubricants must be selected from the tables below, containing
oils and greases recommended by the respective brand name owners. The required viscosity grade of the oil is mentioned on the
name plate.
If nothing is mentioned on the gear unit's name plate, only mineral oils and greases have to be used.
Synthetic oils may be used only after written authorisation from the Engineering Department of Hansen Industrial Transmissions nv.
(1) Only for low ambient temperatures, see nameplate of the gear unit.
(2) Use only high quality greases, with EP-additives and consistency NLGI-Grade 3. Greases with EP-additives and consistency NLGI-Grade 2
may be used for regreasable labyrinth type seals and grease lubricated lower bearing of the low speed shaft.
(3) Composition formulation of the product designated by the year of its market introduction.
General notes
• If the gear unit is filled with storage oil, it has to be drained and it may in some instances be necessary to rince the gear unit with the
selected oil before starting up. Check with the oil supplier.
• Oil and lubricant manufacturers can change product compositions.
• The lubricating oils with the composition formulations mentioned in the above tables have to be used.
• The greases mentioned in the above table have to be of a product composition formulation of before January 10th 2005; a confirmation
from the grease or oil supplier is essential.
• Hansen Industrial Transmissions nv is not responsible nor liable for composition changes.
The oil and lubricant suppliers are responsible for the selection and composition of their products.
• If the customer does not wish to follow Hansen Industrial Transmissions nv' oil and grease prescriptions, the customer assumes responsibility
for the technical suitability of the lubricant used.
• If the customer would like to use another oil in the gear unit than the oil he last filled in the gear unit, he has to consult the oil supplier
regarding the compatibility of the two oils and the measures that possibly should be taken for reliable operation of the gear unit with the
new oil and the possible residues and/or components of the old oil that could be present in the gear unit.
• Any oil and lubricant shall be handled with care and according to the handling and safety instructions to be supplied by the lubricant
supplier on customer's request.
These instructions have to be handed over to any personnel performing installation, maintenance or repair of the gear unit.
ENGLISH
mm
2
/s
40°C
ISO
VG150 (1)
ISO
VG220
ISO
VG320
ISO
VG460
Bearing grease
AGMA
cSt/50°C
4 EP
90
5 EP
126
6 EP
184
7 EP
230
Graisse pour
roulement
Wälzlagerfett
E/50°C
SUS/100°F
BP
CASTROL
11,9
690
16,6
1100
Enersyn EP-XF 150
Formulation L04025PBA
Alphasyn EP 150
Formulation L98120PBA
Enersyn EP-XF 220
Formulation L04026PBA
Alphasyn EP 220
Formulation L98115PBA
24,3
1600
30,4
2300
Enersyn EP-XF 320
Formulation L04027PBA
Alphasyn EP 320
Formulation L98111PBA
Enersyn EP-XF 460
Formulation L04028PBA
Alphasyn EP 460
Formulation L98113PBA
Lagervet
(2)
FAG Arcanol VIB3
FAG Arcanol VIB3
KLÜBER
(EXXON) MOBIL
(EXXON) MOBIL
SHELL
Klübersynth GEM
4-150 N
Mobilgear SHC XMP 150
Formulation RL001983E
Klübersynth GEM
4-220 N
Mobilgear SHC XMP 220
Formulation RL001983F
Mobil SHC Gear Series
150
Omala HD 150
=
Omala S4 GX 150
Formulation 2007 (3)
Mobil SHC Gear Series
220
Omala HD 220
=
Omala S4 GX 220
Formulation 2007 (3)
TOTAL
Carter SH 220
Formulation I31219
Klübersynth GEM
4-320 N
Mobilgear SHC XMP 320
Formulation RL001983H
Klübersynth GEM
4-460 N
Mobilgear SHC XMP 460
Formulation RL001983J
Mobil SHC Gear Series
320
Omala HD 320
=
Omala S4 GX 320
Formulation 2007 (3)
Mobil SHC Gear Series
460
Omala HD 460
=
Omala S4 GX 460
Formulation 2007 (3)
FAG Arcanol VIB3
FAG Arcanol VIB3
FAG Arcanol VIB3
FAG Arcanol VIB3
Carter SH 320
Formulation I31219
Carter SH 460
Formulation I31219
FAG Arcanol VIB3
40
39

Hansen P4 Series Specifications

General

Brand	Hansen
Model	P4 Series
Category	DC Drives
Language	English