Hansen QHPF1 User Manual

5. HANDLING
The Hansen P4 gear units are easy to handle and to install. Make use of integral oval lifting eyes (horizontal
mount) and lifting eye nuts with bolts or integral rods (vertical mount).
For equal load sharing make use of all available lifting points (4 lifting points), fixed to the gear unit, and use ad-
equate tools.
Never use the lifting eye bolts of components mounted to the gear unit (eg.: motor, coupling, brake, lubrication
system, etc.)
Make use of attached lifting eye nuts or mount the appropriate eye nuts (with bolt) to the lifting points
of the housing.
Eye nuts (with bolt) must be fixed and secured before lifting the gear unit.
Never lift units with slings wrapped around the shafts or motor lantern.
5.1. LIFTING EYE NUTS WITH BOLTS ATTACHED TO THE GEAR UNIT
Horizontal mount
- Single stage gear units (type QHP.1)
Use only the integral lifting eye and appropriate lifting eye nuts with bolts in housing feet
- Multi stage gear units (type QH...)
Use only integral oval lifting eyes
Vertical mount
- Two stage gear units (type QV..2)
- Three and four stage gear units (type QV..3 and QV..4 )
ENGLISH
15
Max. force on the eye nut
(kN)
M16 M20 M22 M24 M27 M30 M33 M36
7
4
12
7
15
8,7
18
10
26
15
36
20
36
20
51
28
45°
Gear unit size C D E F
Bolt size
Grade 8.8
ISO
Low speed shaft side
High speed shaft side
M22 M27 M27
Use only the integral lifting eye
M33
G
M33
Gear unit size C D E F
Bolt size
Grade 8.8
ISO
Low speed shaft side
High speed shaft side
M16
M20
M16
M24
M20
M24
M24
M30
GH
Use only the
integral rods
Gear unit size C D E F
Bolt size
Grade 8.8
ISO
Low speed shaft side
High speed shaft side
M16
M16
M16
M20
M20
M24
M24
M24
GH
M30
M30
M30
M30
14

Hansen QHPF1 Specifications

General

Brand	Hansen
Model	QHPF1
Category	DC Drives
Language	English