Remote control
EN
HDG3000B Quick Guide Copyright © Qingdao Hantek Electronics Co., LTD
16
8 Remote control
HDG3000B-series signal generators can communicate with computer through the USB
interface to achieve remote control. The remote control is implemented based on the
SCPI (Standard Commands for Programmable Instruments) command set.
Software installation
Users can download the application software package of the instrument from the official
website of Hantek:
http://hantek.com.cn/products/detail/12267
Double click the “Setup.exe” file to install according to the installation wizard.
Once the installation is complete, the software icon will be displayed on your computer
desktop.
Keysight IO libraries suite installation
Click on the following URL to download the latest Keysight IO Libraries Suite:
http://www.keysight.com/main/software.jspx?Ckey = 2175637 & lc = chi&cc = CN&nid =
- 11143.0.00 & id = 2175637
Of course, you can download the package from the official website of Hantek.
Double click on the application to start the installation. Follow the installation prompts
step by step, and the installation process may take a few minutes.
You can see the IO program running in the bottom right corner of the screen after the
installation is complete.
When the instrument is powered on, connect the instrument to the computer via a USB
cable. The driver will be installed automatically, and you can see the successful
installation prompt, as shown in the picture below:
After the driver is installed successfully, you can see the driver information in the
Computer Management:
To Next Page
Loading...
Need help?
General
